Home / Contact Us / Service

 

D-2400 High Speed Automatic Strapping Machine

The D2400 is a technically innovative strapping machine capable of over 50 strapping cycles per minute. This machine will accept 5mm, 6mm (1/4”) or 9mm (3/8”) strap (no additional parts or costs required). Cycle initiation is by start switch, photo eye or foot bar and the table height can be adjusted from 29.5” to 35.4”. Operating on single phase power, the machine can be plugged in virtually anywhere in your facility. Equipped with a LCD which can be set to display in six different languages. Capable of being equipped to accept our new XL coils and easy strap feeding, the D2400 minimizes the lost time associated with coil changes.

 

D-2100 Automatic Strapping Machine

The D2100 is an operator friendly strapping machine capable of over 48 strapping cycles per minute. This machine will accept 5mm or 6mm strap (no additional parts or costs required). Cycle initiation is by start switch, table mounted photo switch or foot switch. The table height is set at 800mm (31.5”). Operating on single phase power, the machine can be plugged in virtually anywhere in your facility. The design of this machine includes rounded corners on the table tops for increased personal safety. The coil is internally mounted, which minimizes required floor space, but utilizes an open design so that the coil is visible. Easy automatic strap feeding, loop kick outs and automatic strap discharge of leftover strap once has coil has been exhausted are just a few of the features which make this a user friendly unit. The strapping material is heat sealed for maximum seal efficiency.

 

DF-11 Automatic Strapping Machine

The DF11 is a proven “workhorse” capable of over 37 strapping cycles per minute. It has a rugged frame and roller table top construction. The arch configurations (height and width) increase independently in 200mm (approximately 8”) increments, so configuring for a specific application is not only desirable – it’s doable. Cycle initiation is by start switch, foot switch or optional roller switch. The DF11 has a table height of 795mm (31.3”). Operating on single phase power, the machine can be plugged in virtually anywhere in your facility. This machine can be ordered to run 9mm (3/8”) or 12mm (1/2) strap. The dispenser is internally located which minimizes the required floor space. The strapping material is heat sealed for maximum seal efficiency.